1/2 Shank, 1/4 Radius x 1 Diameter x 1/2 Cutting Length - Roundover Bit, Whiteside #2006

High quality bit with absolutely no tear out.

works

Well Worth the Money. Works great. Havent had any kickback with it.

I build Porch Swings and I use this to get a nice rounded edge on the slats for the swings. In 2 weeks I cut about 3,500 board feet; the bit is still sharp and cutting well. Surprisingly the bearing is holding up as well. Quite satisfied with this purchase.

Perfect for roundover edging on poplar 1”x2” built-in cabinet/shelving countertops. Came quickly and worked great with my Dewalt 618 router. Would definitely recommend and would buy again from same seller.

Very nice bit. Cuts well. Definitely would buy again

I go through about 10 of these a month. Im usually getting in excess of 5,000 thousand feet of routing with each bit on aromatic cedar (a very soft wood). They are exceptionally good surpassing any other bit for end grain. Usually the bearing is the first thing to go. Only one in a hundred get dull before the bearing dies. I have to watch for burning on the wood where the bearing touches to know when to change it out. I may be putting a little too much pressure with my feather boards, but I require that to get the results I want.

Built a table from solid 3/4 red oak to use a Big Green Egg smoker and wanted a finished edge. Bit cut clean and without any burn marks. No problem, fast shipping and reasonable price.

This bit performed perfectly to put a rounded edge on our project of building two Adirondack chairs.

High quality good price