2Pcs 18.31 In Front Lift Supports Compatible With HONDA 1998-2002 ACCORD HOOD Struts 98 99 00 01 02 1998 1999 2000 2001 2002
-
peter russell
> 24 hourEasy to install ,quality parts ,will buy again !
-
Gene
> 24 hourIf one is worn,the hood will drop. Replace them both.
-
Stephon
> 24 hourWorked perfect for my 99 accord ex sedan
-
Edgar Russinke
> 24 hourFácil de instalar , trabajan bien
-
Jose Hernandez
> 24 hourEasy to install & perfect fit for 1999 Honda Accord
-
FrankMMIII
> 24 hourMy 2002 Honda Accord needed new lift supports for the hood because it wouldnt stay up. I ordered these, and they arrived quickly. Installation was pretty easy and straightforward. They work and fit just like OEM, but you need to install both of them. One cant hold the hood up so make sure you brace the hood during installation.
-
S. L.
> 24 hourThese lift supports were very easy to install. One word of caution is loosening the retainer clips. When prying them loose, be careful not to loosen to far as the clip will either pop out or get sideways. Loosen the clip evenly until the ball socket is completely cleared to allow it to fit over the ball joint. I didn’t do this on one of them and it took forever to realign it. Also, if you don’t have something to hold your hood up while doing this, get a helper. Other than that, this process should really take about 10 minutes. These supports are very solid and should last a long time.
-
Michael C.
> 24 hourEasy to install and work well. Just installed today so no review of longevity yet.
- Always replace both lift supports to ensure top performance and to prevent twisting caused by uneven loading.
- Gas charged lift supports typically store a gas charge of over 330 Newton and cannot be compressed by hand.
- Gas charge lift supports can be installed in minutes with no special tools required.
- Careful inspection of all hinges and connecting points should be made for wear and tear or stress fractures. These should be replaced or repaired before lift supports installation.
Important notes:
- When ordering a gas spring, please consider the following :
- Overall length from centre to centre (Extended)
- Pressure
- Type of end fittings
- Year, Make and Model of vehicle
SCHNORKEL is a sealed, gas filled pressure cylinder that exerts an outward force.This force acts like a spring to lift and hold open hatches, bonnets and boots. An exact replacement fit for most applications.
Features
- Superior rod finish - increased seal durability.
- High strength piston seal - superior sealing strength.
- High pressure gas filled - smooth action.
Part Number:
- 74145-S87-A01 , 74145S87A01