3D Printer UV Resin Curing Light with Solar Turntable 360°Rotating Stand for SLA DLP LCD 3D Printer Solidify Photosensitive Resin 405nm UV Resin Affect, DIY Curing Enclosure

It lights up and spins the platform curing my uv resin. Everything Id asked from the product in a very affordable kit.

I bought this specifically the light. Reading previous reviews I learned that the turntable was not very good at all. So I purchased knowing that there was a very good chance it would not work. I was correct. The turntable did not work at all. It did not even run then stop. It never worked. We got curious and opened it up. With the gearbox opened we found the problem. Not only was it poorly made, it was stupidly made. There is supposed to be a motor and a gear set into a frame to operate the turntable. Instead, there were two copies of the gear thrown into the housing and jammed closed. It would never have worked. Meaning that it was never tested. Most likely this was cheap junk purchased off of Wish and resold here. However the light works well. It is set into a DIY curing station and have used it multiple times now. If you can get the light cheaper somewhere else, then go for it. Otherwise, dont buy this for the turntable.

This is a great and affordable option for curing 3D Resin Prints. We built a curing box from a popcorn tin attached the light to side and the rotating thing on the bottom. It works great! QUALITY 5 stars

So out of the box the turntable did not work. I took the cover off the back and discovered that one of the wires was not attached. I hot glued it and it works great now.

Still need to learn how to heal 3D prints, till now I think I cooked too long! But lamp is powerful and good!

Used this to create my own curing station for my resin prints as many other have done. The turn table is very small, so may end up mounting a CD to it so I can actually use it. All in all a purchase I do not regret.

Fast delivery. Well packed. Will be buying more.

Was exactly what I needed

I mainly got this for the light. It works great for curing 3D resin prints. I took a small metal trashcan and placed a homemade wooden lid with a hole cut in the top. The light sits right on top and cures the print. The spinner does move under the light, but can easily be weighed down and refuse to spin. If you are curing 1 or 2 miniatures (32 mm sized bases) it works. Larger or more? Not so much.

Built the enclosure. Tried several different resins (not cheap). Tried different angles, distances, turntables. Then today, I just put the resin coated item out in the sun and BOOM in 10 mins it was fully cured. This light, does NOT cure resin. Going to return. If you have one of these lights and your resin is still tacky after say...an hour or 6 hours in my case, try putting it out in the sunlight on the turntable for 10-15 mins. You will see. This light is crap.