6 Pieces Stainless Steel Bore Brush in Different Sizes Twisted Wire Stainless Steel Cleaning Brush with Handle 1/4 Inch Hex Shank for Power Drill Impact Driver, 4 Inch in Length

Installed on my cordless drill and went to clean out some dirty, oily crudy threaded holes. Stuck in the brush and it started to clean out the hole. I sprayed some WD40 and proceeded to pull the brush in and out and something happened not sure if one of the hairs got stuck on something and it just snapped. Figured it was to good to be true.

Wire brushes fell off after one use, wire shafts broke

I bought these to clear away a bit of rust/corrosion in a few Craftsman sockets. I used the first brush for less than 20 seconds and the bristles had already started to deform, wrapping tighter around the shank. I was able to get the job done this time, but wonder how many more uses Ill be able to get from them.

These are alright. Once you use them a couple of times the bristles get matted down which makes them more difficult to use. I broke one as well. They bend easily as well so if you’re not trying to do any tough work these are fine. If you do something that requires some force these are not for you

Nice brushes for use on a drill

NA

I use the brushes to clean bushings.

Perfect for my project.

I bought these because Ive always dreamed of a brush that i could put in my drill and make quick and thorough work of cleaning up the inner surface of my automotive battery terminals. All it takes is a zip, zip and its good as new.

They snap with any applied pressure