8mm OD 20mm Long Light Load Compression Mould Die Spring Yellow Compression Mould Die Spring for The Ender 3s Bed 20pcs

Works perfectly

I am confused by all the other reviews stating these worked well with their ender 3 v2 printer. I was excited to install these, but even at full compression they are simply too long, and the bed is not able to go low enough without contacting the nozzle at the home position. I tightened down the leveling knobs all the way to where the coils of the springs were completely touching and could not go any more. I still needed the bed to go about 1-2 mm lower. I still plan to use these and just cut off one or two coils. They are much stronger, and seem like they would work well, just frustrated they advertise they fit the Ender 3 V2 when they didn’t fit my stock setup. It may have to do with the bed surface thickness you are using. I am using the textured glass bed that comes with the printer. If you have a thinner bed surface these may work fine.

Seriously, the amount of tension in these springs make it so that you dont have to keep adjusting your bed. They are worth it.

Works as expected and are worth the money.

I replaced the old springs on my A5S 3d printer with these and the reliability and durability has made a huge difference on my prints. No longer having to re-level the build plate after every print. A very good value for the product . The package came with quite a few springs, so I know I will be set for quite a while.

Better than stock springs.

Springs seem high quality. They were a little longer than I expected. They were easy to install on my Ender 3 clone.

Worked great and helped keep my bed level longer.

This made a world of difference when it came to leveling my Geeetech A10 bed. This should be one of the first upgrades you buy for your printer

Significantly more tension than stock ender 3 springs. Also shed light on print quality issues I was having. I had minor z banding and basically rebuilt the entire machine. Changed wheels, z rod, coupler, brass nut, types of lube, resquared the frame on the z, almost rebuilt it from scratch and print quality remained the same. Tried these springs.... bed much more stable and z banding only noticeable at the right reflective angle and under a microscope. Now z banding has been traced to direction changes on different layers so I’m guessing nozzle quality now to make it absolutely perfect. Long story short (too late I know) excellent for me so far. May try the red and blue springs if I get ocd again but for now I’m very satisfied.