ALL PARTS ETC. 1.25 Inch Vacuum Extension Wands, Accessories and Attachments 32mm, 15.75 Extension Wands for Shop Vac Extension Wand Attachment Vacuum Pipe Tubes with 1-1/4 Fitting (3 Pack - 16)

Brush spins only if not touching the floor. Weak even on hard floors. Tried with my central vac and Dyson canister. Anything larger than a toenail clipping will jam the turbine. Forget hair pickup - it will permanently wrap around the brush with no good way to clean it out. Once you open the turbine clean-out flap it will never latch again - snags on carpet and edges and pops open. Wheels are ok on hard floors. Head is so low that anything thicker than paper gets pushed around. I just have nothing good to say.

Just what I needed as my old brush was down to the plastic!

OUR SHARK HAS A VERY SHARP CURVE AT THE END OF THE VACUUM STICK WHICH IS HARD TO PUT UNDER THE BED. BOUGHT THESE TO MAKE IT EASIER TO FIT UNDER THE BED. HAD TO REALLY TURN AND SQUEEZE THE STICKS INTO THE SHARK SO IT WOULDNT POP OUT. SO I GAVE IT 4 STARS.

Wish i would read the size better. It is exactly what it says it is. Just smaller then i wanted.

Good for replacement wand.

I am so glad these worked and it makes it a lot easier on several of my cleaning jobs, I love these extension wands and am well pleased with the quality of them and ease of use.

I think the hair on these are WAY too dense and long. I was losing suction because my mini shop vac was sucking the bristles inward and closing off the hole. I had to trim away probably close to half of the bristles before it would work properly. It works fine now after trimming, but barely at all as-is out of the packaging.

Very nice company to deal with. Parts arrived quickly and work as advertised.

These are inexpensive tubes, but exactly what I was looking for to use with my mini 1 gallon shop vacuum.

Works good but fit is lose.