ALLICAVER Compatible Wall Mount Netgear Orbi, Sturdy Metal Made Mount Stand Holder Compatible Orbi WiFi Router RBS40, RBK40, RBS50, RBK50, AC2200, AC3000. (1 pcs)

Solid and well made

The price is a bit much for what this does, but it does it well.

This is a metal sturdy mount! I use this for my RBS50, and theres no issues with fit or installation. My only negative is that I wish it were just a little bit further from the wall to accommodate cords, but were making it work.

Did what it is suppose to do. No issue.

Install was easy. No problems after being bumped a few times. would buy again

Wi-Fi routers are great and they have better coverage the higher you mount them in your home. I tried another plastic mount but it was junk so I bought this wall mount since it was metal Pros Easy to mount VERY sturdy - doesnt bend, flex or look like its going to snap like the plastic one I tried Gives plenty of space for running the power and network cable to it The white painted finish is smooth and looks great Cons The only con I have is the supplied screws and wall anchors. Theyre cheap....spend a buck or two at the local hardware store and pick up some better screws and anchors After raising my Orbi router from a small table top to about 7 feet high on the wall, I get a much stronger signal throughout the entire house. For the price it was a great buy and I had wished I purchased this mount sooner.

Simple, well-made, sturdy (steel) and powder coat finished bracket. I cant imagine how the plastic units that cost 2X as much could do any better.

OK, so I wanted something to wall-mount my Orbi RBR50 router in the garage where my cable modem and miscellaneous network gear is located. I hated having that mess of equipment and wires on a shelf, so I bought some wall mounts. This is the only one that was made for the product. It fits well, and is made out of some serious steel. Its actually a bit overkill for the router, but I like things that are heavy duty! Plenty of room for cables, too.

Installation was no problem. The Orbi fit perfectly.

I have the RBK50 set with the RBR50 router and the equally sized RBS50 satellites and this is a pretty exact fit. Its made from decent enough metal, given what the Orbi weighs. Installation is standard DIY stuff. They provide screws and drywall anchors, but I only required one wood screw into a stud - your mileage may vary. The mounting plate is 2 1/2 high and just under 6 wide, with the mounting holes 1/2 in from the sides. The bottom has openings for ventilation and to squeeze in 4 ethernet cables and the power cord. Theres still enough room to push the power and sync buttons. For what it is, I think its about $5 more than it should be. But its an easy solution to a first world problem.