anidees Aluminum Heat Sinks Extra High Pi Case with Silicone Thermal Pad for Raspberry Pi 4 Model B Black (AI-PI4-BB-PRO-H)

Its not just taller than other models, it has the CNCed heatsink that is amazing. I put a PoE hat in mine and run it hard. The whole body gets quite warm, but it doesnt throttle. its also a really good looking case.

Probably, this is the best case I had ever seen and use. Height is enough to put inside original Raspberry Pi PoE HAT without a fan and fan HAT. Now I have nice looking cold and silent computer.

Fast shipping, sleek design, easy assembly. Looks great, I would buy it again; definitely!

Fantastic case. Solid, professional and very well cooled. You cant beat Anidees cases.

Dieses Gehäuse lässt den Pi nicht schwitzen, er läuft auf ca. 30c im pihole Modus dahin. Ich will es nicht mehr missen

This is a great case. Very stylish looking with the acrylic top it offers excellent cooling and can be enhanced with a fan . Work great with the raspberry pi 4 8gb board.

With the cheap heat sinks and under normal CPU load the PI4 was doing about 53 degC and under a moderate load it was getting up to 70 degC. After the case was installed the temperature under moderate load was between 40-45 degC and normal load was about 35 degC. This was all without a fan and with a HAT on top. It was a little tricky getting the HAT installed, the same screw tap that holds the PI4 on the bottom of the case also holds the standoff for the HAT on the other side. I used a plastic standoff with a short screw thread sticking out. The only real downside is the cost. The case is well made and they give you an allen wrench and the silicon pads to transfer the heat to the heat sink. They also include an extra screw of each type and an extra rubber foot pad.

This case has quickly become my favorite Pi 4 case. The build quality is amazing and the attention to detail is evident. There is a slot for a GPIO cable to be run without interfering with the cover. There are also spacers supplied to add a little space between the top of the case and the cover for extra clearance if needed for a HAT, or for extra air flow for cooling. This case does an amazing job of cooling the pi. With only the case for a heat sink, a stock pi 4 even under fairly heavy use will not reach thermal throttling temperature (80 C). In normal every day use, it is very stable in the 30s most of the time with a peak into the 40s with extended activity. Under stress conditions, where all 4 processors are running at 100% it reaches the mid 50s but no higher... perfectly acceptable! If youre interested in overclocking, where cooling is a must, this case also performs well. An overclocked pi in normal use will still not reach throttle temps in this case unless run hard for a long period of time. Once the activity stops, the temperature drops quickly. There are holes for mounting a 25 or 30 mm fan, or a fan HAT type board if preferred. With the addition of a fan, even an overclocked pi can handle extended periods of 100% usage... something most of us wont do in day to day use. There is room within the case for a HAT to be mounted if desired. A GPIO extender may be needed, depending on the hat, but it will fit comfortably, and the clear top gives excellent visibility for any lights or indicators on the HAT, or just the LEDs of the Pi itself. In short, the Anidees Heat Sink case is an investment you wont regret. It is both a case and cooling solution in one, and has lots of options for other options as you begin to experiment with your Pi.

The black coating isnt evenly applied. There seems to be a corner that didnt get the coating properly applied and I guess someone used a black marker or something to cover it up.

No dislikes whatsoever. Well made and just what I needed to accommodate my lightening detector for my weather station. This is my second case from them.