Atwood 93868 Water Heater Replacement Parts - Spark & Sensor Electrode, 2-Prong (1)

This, along with the new thermostat I bought, was an easy way to clean up and restore my old water heater. Works great. Only problem is it did not come with the cap for the connection where I plug into the circuit board, which is not possible to take off the old one without destroying it. But other than that, it works great

Our Atwood GC6AA-10E water heater would go through 6 to 8 start ups, where it would spark, light and burn for 2 seconds and go out. Then after that it would start and work. But it would fail again. after overnight cooling off. Guessed that there was no milliamp voltage from electrode. being fed back to control board to keep the gas on after lighting. This new electrode seems to have solved the problem. Starts like a champ now. Lucked out it was not the board.

The screw and hole were different sizes. I had to find a substitute. Other than that, it worked as expected.

It was very easy to install and its working.

I like the fit as it worked out nice for my 2004 coachman freedom series. Youll need a small socket to install ignighter ,believe it was 1/4 .

works well

The rubber boot is not the correct size but it does work

Quick & easy to install

Easy install and fit just like the original. Works great

The original screw hole on my Dometic/Atwood Model# GC6AA-10E is not the same size as this replacement so I had to drill it out and then just ended up replacing it with a washer, but, and screw. Original screw was just a worthless sheet metal screw that barely held it in anyway.