Brady Authentic (M21-1500-427) Self-Laminating Wire Wrap for Control and Electrical Panels, Datacom Cables, Black on White- For M210, M210-LAB, M211, BMP21-PLUS and BMP21-LAB Printers, 1.5 W 14 L

Very useful and handy. Used already 4 in 2 months

Great labels that will stay attached to cables for years and not peel off. However they are rather expensive, so drop a star. However I’ve not found anything else that stands the test of time.

Very sticky when you want it, but easy to peel off if you need to. Use the P-touch labeler for nice clean prints.

excellent product

Works great, just wish the printable area was 3/4 rather than the 1/2 it is.

This product says its sold in a pack of 4 but you only get 1.

I use these labels for marking ethernet cables. They hold up very well and are a lot better than labels that stick out

The best labels for low voltage wiring.

By far the cleanest way to label Cat5/6/7, HDMI, Coax, etc. cables. I used to use flag type of label, but when you have a 48-port switch, that becomes a mess. These are clean, wrapped around cable with translucent protective layer over top. Best solution by far, short of buying a $700 commercial label printer. Oh, and shell out money for your label printer power cable. Batteries die like crazy.

This has a long transparent tail that allows you to wrap the clear film around the printed label. That way the print wont wear off. Good design. I like it much better than the 3/4 version, which never has enough length to go fully around the wire and protect the printed label.