







Cable Matters 5 Pack RG6 Keystone Jack Insert, Coaxial Keystone Jack Insert Gender Changer
-
Holbywan
> 3 dayThey dont fit into the Ethernet Wall plates I ordered. Fortunately I had some old ones around that were smaller and fit fine. These are just a little too big, must be a proprietary thing? Never had this happen before.
-
Kenneth L.
Greater than one week3mhz barrel, and a strong clip that wont pop out if the coax pushes on it.
-
C. DeBolt
> 3 daybetter than what it replaced.
-
AK
Greater than one weekI think the manufacturer could also easily offer packs of 3 pieces.
-
Chris
> 3 daySuper tight fit in face plate, decent amount of force to fully seat and a PIA to get out without damaging the hinge. using MonoPrice face plates. this is a common issue with most manufactures of this product type.
-
John K.
> 3 dayThese are functional and there is no loss of signal. However, when compared to other keystone inserts for CAT5, etc, the plastic seems thin. They snap in solidly, but if the coax wants to push/pull, these will pop out without a ton of effort. In other words, I expect to have to squeeze hard to release the tabs to remove these, however, just pulling downward with the attached cable on the back will cause these to release. Mostly an issue during installation, so as long as the cable is not moving around behind the wall, they should not pop out once fully installed. Meh, could be better.
-
Atheist_Shopper
> 3 dayWorked
-
BK
> 3 daygood
-
Bazza
> 3 daywork as expected.
-
purdueboiler91
> 3 dayThese worked very well with my Keystone wall plate. Would purchase again.