CK T3327GTM LaYZr Tungsten Electrode 3/32 x 7, 10 pack

I love this product, but I dont understand how 3 week mystery shipping with 0 tracking is acceptable. Will be pursuing other products because CK is such a slow drop shipper.

I just did some experimenting with my 3/32 when I first got them to see if there was a noticeable difference to the ceriated and lanthanated that I use for steel and aluminum, respectively. Aluminum was first. I ground a nice sharp point for my inverter and ran a few 4043 beads on 1/4 6061. The standout difference I noticed was after several rods, there was no splitting on the very tip, and very little ball formation on the point even running at 30% EP. No spitting either, though it was a short session and I dont get much from the La electrodes either. During the session, being an old shaky guy, I duffed the electrode a few times, but it shook it off like a champ and I kept on going. Then a fly flew into my arc and exploded carbon all over. same result, just kept going. End of session a small sphere had formed but little else and didnt have to re-sharpen once. Then on to steel. I put a nice slender point on the electrode and ran some beads on different thicknesses from .040 to 1/2 steel and some stainless. The several rods later, the point looked the same as when I started. It stayed clean and sharp. Further, to test the low amperage behavior, I welded some rod remnants together. My machine has a hard start, so it takes bit of control to stick an .040 rod together. All went well and Im really considering putting my La and Ce on the shelf and just working with these. Really happy with them and will be getting some 1/16

Despite the fact that they start well at low amperages and stay sharp, which ultimately makes them a fantastic replacement for Ceriated tungsten...the arc however is not crisp and direct at low amperages. It wanders. This is bad and its just as problematic as ceriated tungsten which wanders as well. I have to do micro welding in which I place a weld between two items but this tungsten will arc jump onto the other materials or surfaces. It ruins my parts and makes me very angry. Lanthanated and thoriated tungsten do not do this. Layzr tungsten is not better than 2% lanthanated. It does stay very sharp and its very visible so its a quality product per se...but I will not buy these tungsten again. I bought these for $20 a pack, and about 2-3 months later, they are now up to $30. They are not worth it.

I have an AHP Alphatig 201XD and this chartreuse tungsten has held up really well, even with the balance turned up a little higher than normal. Seems to take a lot for it to ball up, which is fine since Im on an inverter machine. It also breaks cleanly with just a little tap, instead of splitting.

Excellent quality tungsten. Holds a sharp point!

Absolute favorite

I have not had chance to try these but have read a lot of good reviews about them.

These start nice and retain a point well. I use them for both aluminum and mild steel with great results. Makes me feel like Im back in the weld shop 30 years ago.

High quality

These Tungstens seem to keep a nice sharp point better than Lanthenated.