Creality Ender Enclosure Fireproof and Dustproof for Ender 3V2/Ender 3V2 Neo/Ender 3 Pro/Ender 3/Ender 3 Neo for Anycubic Elegoo 3D Printer 18.89 * 23.62 * 28.34/480 * 600 * 720mm

A zipper pulled right off the end because the item wasnt sewn in correctly.

This enclosure is huge. No real clear direction to assemble it but wasnt hard to figure out. I got it for a Endeds3v2 and only problem I see is if you use the stock spool holder on top of the printer it will be taller than the enclosure. So youll have to feed it from outside of the enclosure but there isnt an opening in the side of the enclosure to do so.

This is nice and easy to setup. However, I wish it was about 5 inches bigger on each of the sides. Not much room inside once you put your printer in it.

This foil lined fabric enclosure keeps dirt and dust off the printer, it also prevents drafts and temperature swings that cause prints to warp. Temperatures inside when printing range from 80°F for PLA to 105°F for ABS. If covered with a blanket, temps can go to 95-115°F as a heated chamber for PA, PC, and nylon.

Limits the horrible smell of the printer and keeps temperature steady.

Easy installation. I just love it. Worth the money and also it’s cheaper then the other stores.

Just bought two days ago. Easy to assemble. Glass fiber is strong and lighter than metal. Like a small room for my printer. My office no longer have plastic smell. Noise cannot be eliminated but is reduced for sure.

My wife was terrified my printer would burn the house down. But the best part about this is it keeps the temperature constant.

The enclosure that i received did not have stainless metal polls as the videos and pictures on this page show, the polls and all the corners were plastic. They still do the job but be careful when ordering. This also did not show up in a creality marked box and did not have a certificate from them inside the package.

Definitely keeps the heat in, and the peace of mind that its fire proof makes a big deal to me. There are bigger cheaper ones on the market though. I paid for the logo.