Diamond K400CNMO Trunk/Hatchback Mount With 2-Axis Adjustment, NMO Base and 6 Foot Coax

Solid construction and very easy to adjust for optimal orientation of the antenna. This mount is flat making it best suited for locations where the lip and fender are relatively flat and even. In my case the fender was slightly higher than the trunk surface so the small center tab had to be bent up slightly for a perfect fit. It also includes an aluminum strip that goes between the underside of the trunk lip and the set screws providing a very solid attachment with no noticeable impact to the vehicle. The coax is very thin so it fits in very tight clearance locations. Thinner coax may not be as efficient as some but it’s relatively short and seems to be of good quality. Time will tell how well it weathers but it appears to be built to last.

Very happy with quality and is simple to attach. Take your antenna on and off by unscrewing NMO or loosen one bolt and fold your antenna down flat to go inside parking decks with low clearance. Folding requires Allen key provided. Either way is quick.

Was looking for a mount for a Hyundai Tucson. This one does the job. It came with a very thin coax that did not reach from the hatchback to the front so I had to install 6 feet of low loss coax. Signal reports were ok. Reception seems better than the mag mount. Because it’s mounted on the side, a bit lower than the roof mag mount was, I’m able to use a full half wave antenna.

Mount is easy to install and adjustable to any position you could need to keep antenna vertically.