Dot Genie Google WiFi Pro Outlet Holder Mount [Old and New 2020 Version]: The Strongest, Most Versatile Mount Stand Holder for Google WiFi. Great for Home and Businesses! Still No Screws! (2-Pack)

I would have given this 5 stars except that I could only get it to work when installed on the BOTTOM of my outlet. I first tried to install on the side and it fell right out. Maybe that is because I have the older outlet type with a single screw in the middle, between the two receptacles. Hangs down just fine and seems secure enough. I initially tried winding the cord by inserting the plug in the puck and then winding out, but that didnt put the electric plug where I needed it. I ended up starting w/ the electric plug where I wanted it, and then winding it in (starting w/ the outermost ring first) and finally plugging into the the puck. Also, note that you can/should wind the cord 2x into each ring -- if you only put a single wind into each ring you will end up w/ a lot of extra cord. Recommended, especially if you are good w/ it being installed on the bottom.

Wish I found this product earlier. I’ve been using the other type where all the weight sits on the prongs, loosening the outlet over time. With this mount, weight sits on the outlet face. Love it!

I recently purchased the google whole home Wifi system and decided to try these outlet mounts so the routers would not have to sit on top of furniture. The mounts seem to be very secure, and I did not notice any movement of the mounts after installing them behind the wall plates. I did attempt to wrap the cord around the mount several times before finally being satisfied with the tension in the cord while plugged in. Other than that, installation was a breeze.

It seems like the Google Home is a little too heavy for this product as it bends the outlet cover while it it hanging on it. But it’s easy to install and comes with good instructions. It keeps the Google Home out of the way like it’s supposed to.

Great option to tidy up your wifi hub. I installed it from the side (rather than from the top or bottom of the outlet). Very nice indeed.

like it. very easy to install.

Our house has new outlet face-plates with one screw in the center. These holders, when empty, barely stay in. When you put the Google wifi device, they fall out immediately. So: these are easy to install and easy to use, and probably work fine if the outlet is in a good position (out of the way of traffic, and in a good location for wifi signal strength), but ONLY if the face-plate of the outlet has two screws.

I hate giving 1 start reviews but sometimes its necessary. Poor design. Did not stay in place. Actually fell off the wall. Dont even think about buying these. I returned mine.

Clever design shifts support of the weight of Google wifi to your outlet cover plate. Unlike other designs the plug isnt used to hold any weight. The Google WiFi is heavy enough you do not want the plug to support weight since it will fall out over time. This outlet design solves that problem. You should note this design depends on the cover plate to be ridged. I had one cover plate that was vinyl and could not support the holder tight enough. But an outlet cover is an easy and inexpensive replacement if needed. Since the Google Wifi plug isnt used by the outlet holder your outlet can easily use both plugs of outlets. Other holder designs may interfere with the second plug. This holder is a great simple but solid design. I never need to worry about this failing and having the Google WiFi unplugged. Highly recommended.

Nothing worse than chords and wires hanging on the floor or having to set it on the ground. The cord is able to be wound up inside leaving a clean look and less mess. We bought one for each one we own.