Drill America - DWT54506 5/16-18 UNC High Speed Steel Bottoming Tap, (Pack of 1)

Good quality and cuts through aluminum like butter.

This tap worked for me. Had to redo a cross threaded bolt hole on my Harley. Just took it slow with plenty of oil, and after a few turns I was able to restore the threads. Just take your time.

It works. But it’s too small for my application

This 5/8-28 tap matches the thread in the tail of a 2AA Mini Maglite. I had a battery leak, and the resulting corrosion made it very difficult to unscrew the tail cap (I had to clamp it in a chuck). I eventually got it apart, extracted the batteries, and scraped out the residue, but the threads were badly galled. I used a needle file to clean up the external threads on the tail cap, but had to buy this tap to re-cut the internal threads. Note that some internet sources say the Mini Maglite has a 27-pitch instead of a 28-pitch thread. While a 27-pitch thread would probably work just fine (since the threaded part of the cap is only about four threads long), I inspected the Maglite threads under a microscope with a thread gauge and I am certain it is actually 28 TPI. I had no problem re-cutting the internal threads with this tap, and the tail cap now screws right in. Of course, for the price of this tap I could have just bought a new flashlight. But I generally err on the side of buying new tools, and these flashlights are very common (there are at least three in my household) so Im sure this wont be my only opportunity to use it.

I use a cheap one to chase stuff etc but this was hi quality to me anyway

Great for mounting sights on guns.

Cut threads very well into extruded aluminum

Tapped hole in 12L14 steel in one pass, no need to backout to clear chips! Very nice quality.

I received this product and it was of great quality and completed the job perfectly. I used it to tap aluminum piping. Unfortunately after completing the job, I realized I had purchased the wrong size. Overall though, it did a great job at what I ordered it to do. Thank you!

I hand tapped over 30 holes at 4mm depth for some grub screws and they all came out perfect. Lots of the negative comments are from misuse. Remember to use cutting oil and back out a little constantly. Most importantly, make sure you are pre-drilling the right size diameter hole before tapping. The correct size can be found online. For an M4 tap, you need a 3.3mm hole.