



Drill America DWTT1/2-13 1/2-13 Carbon Steel Taper Tap (Pack of 1), DWT Series, Uncoated (Bright)
-
Janette Cherba
> 3 dayI used this to chase threads in blind holes in an automotive cast iron housing prior to reassembly. It did the job I needed and after waiting for more than two weeks for the local hardware to obtain one of these taps, I had this one through amazon to use in two days for slightly less cost.
-
Michael chance
> 3 dayI use this tap on a small block Chevy bell housing just to clean the threads if they get rusty or whatever just for clean up and Ill get a good bolt makes a good bolt thread for your new bolts
-
Stephen Howden
> 3 dayUsed it to mount a AXA tool post changer.
-
Tammy S.
> 3 dayI didnt need all 3 but it was a size I didnt have out of my 500 taps I have so I figured get all 3 . For me this is the size for my 3point hitch on my tractor
-
Dan Powsa
> 3 dayI bought the set for a one-time use of this odd size (M13x1.5). Price was right at about 1/3 the cost of other taps but the steel isnt top quality. The worked well to cut the threads I needed in cast 6061 aluminum. They came out clean, sharp and accurate but I dont think the taps will hold up for the long haul. Theyre a very good value for limited use. If you need to cut a lot of threads or plan to keep them for years, youd be better off spending more and getting better quality tools.
-
James
06-06-2025Good Value.
-
Panfilov_Dmitri
> 3 daygood!
-
greg
08-06-2025Bought to thread in a Grovtec Push Button Base into a Luth-AR MBA Buttstock. Easy peasy
-
Hugh Lee Helmly IV
> 3 dayrare size tap, did what i needed it to
-
Rufus Finley
> 3 dayI used these to prep a new steel bicycle frame derailleur nut. Because the paint was in the threads, I could not properly screw on the derailleur. I used the more blunt one first, as I had already crossed the threads with repeated failed attempts, then I proceed to use the sharper one for a final cleanup. Very effective! Derailleur screwed right in afterwards.