













DS18 DPIV1/0 Pair of Copper Dual 1/0 Gauge to 1/0 Gauge Amp Input Reducers with Offset Stub - Adapter to Add Two 0 Gauge Terminals to Single Zero Gauge Terminal Input Amplifier
-
Benedict Hoeger
> 24 hourCar amplifiers
-
jonathan rosario
> 24 hourNice but too big for my amp need a 10k plus amp for these
-
Briana Kreiger
> 24 hourThere gd
-
Areacode215
> 24 hourVery heavy and great quality.
-
Andre
> 24 hourLooks good haven’t used yet.
-
ubmbass
> 24 hourThese work great, Im getting more power out of my 8k now. Thanks!
-
Van
> 24 hourOk these are very well made. I used them on my knu koncepts battery terminals positive side(battery terminal only came with 1 each 8 4 and 1/0 gauge). This way I could run a 1/0 from alternator to positive terminal then the 2nd opening to the rear of the car to power both my amps. It does take a 1/0 ferrule so was a big plus. This thing made my install look clean.....
-
Bob
> 24 hourWaiting on power to go out to install..
-
Jasper B
> 24 hourGood heavy duty feel to them set screws hold wire well and it can fit oversized 1/0 ga wire should you need to. I used them for all 3 12v+ and all 3 grounds to my amp. They work well. Would recommend.
-
Keith E. Sleezer
> 24 hourDidnt end up using these for my project but they look and feel like quality parts.