E3D Genuine Heater Cartridge - 24v 40w (E-HEATER-24V-40W)

The quality of construction looks superb. The problem is the photo in the listing does not match what is shipping. The wires are white, BUT, it does not have the right angle feed into the cartridge, and more importantly, it does not have the plug as shown to detach quickly when swapping a hotend.

The two specific features I was interested in were not included in the parts that arrived. After reviewing the e3d website, the unit pictured is a new specialty e3d high-temperature heater cartridge. Of additional concern, the configuration that arrived doesnt seem to appear on e3ds site -- there is no all-white basic heater cartridge that I can find. It leaves me wondering if these are counterfeit. In any event, it has been a hassle and an unfortunate waste of time. I have returned the four I ordered for a refund. Edit -- after staring at the packages for two days, I cancelled the return rather than have to go out of my way to drop them off at a UPS store. Im sure theyre adequate for $11 heaters -- they just dont have the features pictured, and those features would make a huge difference in the utility of this product.

I chose an authorized reseller for this item. Mine was the white one and it works great on my Prusa MK3S+. The cable on this is a little longer than the original but its not bad.

How was thrown off by the white wires as well however I got my order from reputable reseller printed solid and also came with white cables, seems like e3d has switched colors, just wanted to assure whoever buys this and gets white colored wires not to worry also you could tell if its genuine e3d if there is writing on it and the ends are sealed and beveled unlike cheap Chinese which are hollow slightly

I made sure I bought from the vendor others recommended to get a legit one. Works well when I needed to replace my heater cartridge on my MK3s. Would buy again if I need a replacement.

Needed to replace the heater cartridge on my Prusa MK3S. Arrived next day and works perfectly!

Does the job. Replaced my old one on a Prusa i3 MK3S that got ruined by a blob incident. The wires I got are white.

Works great, but was thrown off when the heater supplied was white, instead of red. I order lots of parts directly from e3D and this is the first white 24v 40w heater that I’ve encountered. Seller might consider updating the info or product image.

Well it looks nothing like the picture.... it works but we’ll see how effectively. Basically a scam.

This works well in my Prusa i3 MK3S. Theres not much more to say than that. It replaced the one that my printer came with after I broke the connection to the old one when trying to hot tighten my nozzle. One thing to note is that I was sent a white one, not a red one as shown. I dont know if the items description says colors may vary, or not. And, really, how much of the cable do I see? And, really, do I even care? Also, Ive noticed that the hot end tends to shoot past the target temp by about 2-3 degrees C before settling back down. I dont remember if the old one did that, so Im just assuming it did, and that this one is no different.