







Easy Wood Tools Mid-Size Easy Hollower #1 (6601) Hollowing Woodturning Tool
-
Giovanny Eichmann
> 3 daygreat tool
-
Jake
> 3 dayThis is a very fine cutting tool. Great for smaller detail work.
-
Augustine Crist
> 3 dayI own several Easy Wood Tools and have been very happy with all of them. Just like all the others I have purchased this one is great quality and works well. The fact that the carbide tip stays sharp for a long time and is replaceable when it does get dull really decreases project time - no more sharpening! I also like the fact that they are made in the USA. I would happily recommend this tool to any of my woodturning friends.
-
love2sew
> 3 dayHusband loves it, says it works great.
-
J. A. Elwood
> 3 dayexcellent tool, great design, easy to use even for beginners
-
Tim ponder
> 3 dayI use this tool daily exile turning wood on my lathe
-
nchris44
Greater than one weekThis is a great tool for hollowing narrow turnings.Has a good reach to get in deep
-
Michael J
> 3 dayI’m a relative newcomer to wood turning, and I’ve found that carbide tools really speed up the learning process. You don’t need a grinder or jigs, and with care, you can get a very fine finish. I do have a a set of traditional high speed steel tools I picked up used, but my Easy Wood Tools tools are my go-to choice for most uses. This particular tool is great for hollowing out vessels like vases that have a relatively large interior and small mouth. I’ll probably end up buying the other EWT hollowing tools as well.
-
Richard Anamier
> 3 dayvery nice
-
Thorn495
> 3 dayGood hollowing tool. I had trouble with it at first because I was using lower RPM speeds on the lathe and trying to cut too aggressively with it which would result in my hollow form ending up off-center in the chuck. It sucks trying to hollow something that isnt perfectly centered and trying to re-center it. My best results with this tool have been taking lighter cuts at the fastest RPM that I can achieve safely. As soon as I feel the tool vibrate in my hand, I back off from cutting with it. Ive found that I can even hollow past the Maximum Overhang sticker at 4.5 and use the full length of the tool shaft (8.5) with ease. The tool is also good for small and delicate spindle work as well.