Firestik MKM2 Molded Side Mount with 18 ft. Fire-Flex Coax -W-Lugs
-
Peter
> 3 dayMost of the people in our off road trail group has these and were very pleased with the performance, installed very easily and quality was great. Would highly recommend.
-
Matt..Or.
Greater than one weekIm using this because I wanted a high-gain antenna and the body panels on my Bronco are too tight to put coax thru for a front fender mount. May have to buy another one and co-phase them. Mounting point is just behind the door.
-
Eric ludwig
> 3 dayMounted cb antenna on body of Jeep. Worked out nicely. Only issue I had is the surface to the antenna it beveled slightly causing lean. I shimmed it with a washer.
-
Dalton B.
> 3 dayBought this to go on my 2004 Jeep Wrangler TJ. I installed it under the passenger side tail light with my 5 foot Firestik antenna and Firestik spring. Works great, havent had any issues. My Cobra CB works very good with it too. I drilled two holes in the body as instructed to mount it and then I also drilled a hole in the very back of the Jeep close the the rear passenger side roll bar mount to run the wires through. I did that then ran the wires along the side of the Jeep (I dont have carpet so now way to hide them that way) and up the passenger side A-Pillar to reach my overhead mounted CB radio. Sorry the only picture I have is from far away at the moment, but I will update it eventually with more. Ran this for a couple months with no issues. I love this mount because this it almost looks factory and no wires are visible.
-
Chad berg
Greater than one weekNothing
-
Chris
> 3 dayThe mount itself is great. The cable was just the right length for my application. However, the eyelet for the cable was too small to fit over the stud on the mount. I ended up being forced to replace it with a larger one. Not a big deal for me, but some buyers may not be handy with a soldering iron.
-
Wyatt Beard
> 3 dayI bought these (2) for mounting my CB and Scanner Antennas without having to drill holes in the body of my truck. Theyre mounted on the back side of my truck bed tool box and they kept me from running a separate ground wire. Mated to the firestick purchased at the same time and hooked to the new Uniden sideband, I was able to obtain a 1 to 1 match on both channels 1 and 40. Easy to install, very clean look and Id buy them again. Thanks Amazon and Firestick!