FivePears 1/2 Inch Shank Rabbet Router Bit with 6 Bearings Set, Adjustable Multiple Depths 1/8, 1/4, 5/16, 3/8, 7/16, 1/2 for Beginner DIY Woodwork …

I had really high hopes for this tool, but it was a total failure. The first time I tried to use it, I went to loosen the small (3 mm?) screw that holds the bearing onto the bit shaft, the screw head stripped. I was using the Allen key that they provided. They tightened the bearing screw soooo tight to the shaft, I couldn’t change out the bearing to the one I wanted to use. After reading other reviews, I now see that there are a bunch of people that have the exact same experience. Very disappointing.

The largest sized spacer in the pack worked great, but the next size down was too much of a difference in size and I was not able to control it well enough to prevent damage to the cutter. I had to take it to a professional. Were I to try this again, I would need to source a bearing that would be 2nd largest. There was two of the same size in the pack so they could have provided an alternate size.

For the cost, you cant beat it. I have used this to make multiple rabbet joints and it has performed flawlessly. I havent had it for a long time so I can speak to how long the edge will last, but so far Im very content with the product.

I AM NOT A PROFESSIONAL WOODWORKER... I needed this bit for ONE task and it did extremely well. I dont know if this bit would hold up to long term use and I really cant compare it to any other brands but It exceeded my needs and expectations for the one job I needed it for.

Home wood working.

So far so good. Appears to be decent quality.

First off, I do not use these bearings in a router environment. I would if necessary, though. I do use the whole set still on the spindle with a couple of washers as spacers to balance mower blades. I found two sets online but had to have a 7/8 bearing for the center hole on my JD blades. These were the ones. Saw a Youtube video on this, and these work just fine. Couldnt believe the difference in my mowing experience after using these to balance my blades. Very inexpensive alternative to the $120-$180 super magnetic version. Very pleased.

Bit and collars packaged in closable plastic containers. Bit performs very well and leaves a good clean rabbet.

Gets the job done but each bearing falls apart every time I use it. Had to switch them all out with ones I already had.

Screw holding in the pieces could be stronger. Works just fine but the first time I used it the screw backed off and then the bearing flow off. So I put it back together and tightened the screw a little bit more and that stripped the screw. I had the correct (included) Allen wrench so no issue on correct size there, seems to be just a weak screw head.