Geekstory BN-220 Dual GPS Glonass Module Navigation TTL Level 9600bps + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Flight Control

Excellent little GPS... takes about 2 -3 minutes the first time and then about 10-15 seconds after that.. I cant complain about this thing at all! It has worked great on my Nazgul5 quad

I used this GPS module to make a 10 Hz GPS based automobile performance meter to measure accurate 0-60 times, 1/8 mile, 1/4 mile etc.

Excellent Gps!, came to life the minute I plugged into Betaflight, the sticky back foam disk works great, Shipping was next day super fast!, couldn’t be happier!

Very good module. Works as expected. Easy to interface with raspberry pi.

I am using this for a GPS device in my car that will light up the LED when I get close to key Points of Interest to remind me of things I keep forgetting (i.e. remember your Chuck-It when you leave the dog park). The picture is a prototype I whipped up to test the unit, as it is my first GPS project. I used arduino nano controller, with the NeoGPS library. Very easy to setup. My first satellite lock took less than a minute, and nearly instant when I am outside. It even gets a lock sitting on my desk indoors which was a surprise and helps for development.

I am using this on a boat. I used a usb to serial module to connect it to the u-blox connect software, so I could change the baud rate to 4800 which is the NMEA 0183 standard. Changes are stored in non volatile memory on this unit, which is not the case on some u-blox receivers.

Pretty easy to setup, only 4 wires to solder. As I recall, the diagram is from the bottom compared to when I was

If you are a part of the FPV drone world, you know breaking parts is part of the game. So this is my third GPS purchased and I have been happy with all 3. Works well, is accurate, and is durable. Definitely recommend!

as expected, just what i ordered.

Acquires sats very quickly and holds them throughout the flight. Make sure to mount with the ceramic side facing up.