HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

Quality replacement for your 24volt printer.

works as expected.

drop in replacement no issues

Fixed my hotend.

Replacement for a failed cartridge in my SV03. Been printing now for 24 straight hours and temp has been steady!

Does the job.

I had to replace my heater cartridge for my Prusa mini and it worked fine. Install was quick. Make sure you have a wire ferrule for the endpoint to connect the cartridge to the printer.

I have this vs the stock heater cartridge and its not terrible. The wires in the end tend to get frayed if youre not careful so thats kind of a bummer. Also one of the cartridges was a tad too big to fit in the hot end so that kinda sucked too but overall it does its job and it has extra rubber insulation so thats good! Probably would just stick with the OEM ones but Im hoping these last longer.

The heating element on this is shorter than the OEM one. But i havent seen it cause any issues yet. But the harness is REALLY short. So when you cut your original one to splice it, make sure you cut a decent amount of excess off.

Was having ‘thermal runaway’ issues. Most likely the thermistor, but I replaced both, and prints have been coming out great ever since!