HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

The heating element on this is shorter than the OEM one. But i havent seen it cause any issues yet. But the harness is REALLY short. So when you cut your original one to splice it, make sure you cut a decent amount of excess off.

Seems to work fine, Havent tested it for true temp etc because the printer just died but it was heating just fine and printing (unless its the cause of the printer dying haha)

Out of the 3 pieces ordered only 2 look usable. 3rd piece had a damaged metal core with only 1 wire, not 2 coming out of it and the 4th was just a single wire with no core. At this point I’m concerned about whether or not to even try the 2 “good” ones to see if they work. Also the length of wires is not consistent.

The first time I heated this above 230 it failed. Not as good as the stock heater in my experience. Must just be a quality control issue because I swapped it out for a new one from this 3 pack and it heats to 230+ with no problems (yet). Disappointing when it says on the product page that it can go all the way to 280. heating above 205 or so takes a long time (5-7 minutes to go from 205 to 250). It takes about 1 to 2 minutes to go from room temp to 205.

All 3 ohm out good around 14.5ohms, but they are only 39 inches long. Stock heater is 56 inches so its just over a foot short of reaching when sleeved with the rest of the wiring.

works as expected.

its working really well

Here is an item that works perfectly. Make sure your psu is 24 volt.

First off, the cord is long enough to reach MB case using the previously routed cable guide. Fit my STOCK hotend from my ender 3 v1. works as advertised. did not have temp gauge to check for accuracy.

I had to replace my heater cartridge for my Prusa mini and it worked fine. Install was quick. Make sure you have a wire ferrule for the endpoint to connect the cartridge to the printer.