













HiLetgo 5pcs A4988 Stepstick Stepper Motor Driver Module with Heat Sink for 3D Printer Reprap Suitable for Mendel Huxley Arduino
-
Joseph Kneebone
> 24 hourWorks good made printer run again just didnt look if they were silent
-
Len
> 24 hourHeres what starred items Amazon wanted me to rate for these stepper drivers. Noise level? Adhesion? Warmth? The vendor should get on them for this nonsense and the poor ratings it might bring. I guess they know not what they sell! But Ill say in defense of the seller and the product that ... Thes are pretty generic, and these work as expected and the delivery was fast.
-
Andre j bridges
> 24 hourAt least one of the five didnt work...Im only using two so I am unsure of the last twos functionality.
-
startrooper
> 24 hourGreat price, drive NEMA 17 in an Arduino CNC shield perfectly. I use the CNC shield, but not for a CNC machine, just for the mounting and pin connections. Highly recommend both.
-
Neuxstone
> 24 hourCouldn’t get a full set that worked!
-
Pablo Arthur Rodger
> 24 hourThey sent me 5, but 3 where in the same pcb and the other 2 in another pcb. Impossible to break without ruining the component. Impossible to put it on a driver of 4. Impossible to setup if your project has motor in different places separated by even small distances. to much wiring. Frustrating.
-
Past
> 24 hourDon’t buy, half didn’t work and one managed to burn up my main board, just go with tmc drivers you will save money in the long run
-
Mary
> 24 hourFour out the five worked fine. The fifth one was all over the place when adjusts were made. Fortunately I only needed the four.
-
Zachary
> 24 hourGood so far, all 5 work.
-
Doctek
> 24 hourItem is of champion quality. Decorous packaging. Swift delivery. Solid seller. A+