LulzBot Mini PEI Sheet

I am not sure what was going on with my previous PEI, but I was using glue sticks consistently and get prints to stick. Since switching the stock PEI over to this one I print directly to the bed with no issue. The prints stick well, but after letting the bed and part cool I am typically easily remove the parts by hand.

After 2 years printing on my Lulzbot Mini 3D printer, the PEI bed was showing signs of wear with lift spots. Time to replace the PEI surface! There are other PEI products available but if you check them closely you will find the adhesive is an additional item. And that process would be rather messy adhering both surfaces without air bubbles! No, the best way is to use authentic Lulzbot Mini products that have the adhesive already attached. I spent a few hours removing the old PEI sheet and cleaning the class bed to remove the remaining sticky residue. Once the glass bed was completely clean and dry I peeled back the new PEI sheet and using a plastic wide putty knife, slowly installed it being careful to remove any air bubbles. I finished by trimming off the excess around the edges. Taking my time on this project netted me a new looking machine that is back to making great 3D prints again! GREAT PRODUCT!

Its perfect as usual. Just scratch the surface with some fine grit and everything sticks very well. Most of my prints are ABS.