



MFJ Enterprises Original MFJ-916B 1.8-225, 350-540 MHz Duplexer - SO-239
-
Justin Tuck
> 3 dayWorked exactly as it should. The description is a little vague but it is both a duplexer and a diplexer. I use it for a diplexer and it works great!
-
Waxman
> 3 dayI think this is one product MFJ can rightly take pride in. It allows you to operate two radios (a 2 meter and 70 cm radio) on one shared antenna...or feed two antennas to one dual band radio. What is does not allow is repeater operation that requires both bands on a single radio. For example, if you set up your radio to call the repeater on the ISS which has an uplink frequency on the 2 meter band and a downlink frequency on the 70 CM band you can have one or the other, but not both, to the same radio. The workaround is to transmit on the 2 meter and receive on on the 70 CM with another radio.
-
Steve Snider
> 3 dayuseful to attach separate 2M/.7M radios to single attena - works well, little loss.
-
Joseph
> 3 dayWorks properly for both VHF and UHF bands. When antenna was measured with a SWR meter before this was installed, I had a 1.01 and 15watts on VHf and a 1.2 and 27watts on UHF with a multi-band Tram antenna. After installing this filter, SWR readings increased by .1 for. VHF and .08 on UHF and the watt output for both fell by 2%, which is exactly what I expected. This increase in SWR affected nothing since it was so small and the ratio was under 1.5. I can receive and transmit simultaneously on both bands. This device is a MUST if you are into ham/GMRS.
-
Rod
> 3 dayif you are using 2 hand helds or mobile units this will go great for your needs and for the money this is the best buy
-
Randy Maggelet
> 3 dayItem is great
-
Zachary B.
Greater than one weekIm not sure what the insertion loss is, but I have this connecting APRS (VHF) and my DMR hotspot (UHF) to a single dual-band antenna. At 40mw from the hotspot, I can use my hotspot at over 3 miles away, so the loss must not be too terribly bad! APRS performing as well...
-
Robert Rodriguez
> 3 dayWorked exactly as advertised. Use it with a cross-band repeater.
-
Jared martinez
> 3 dayMfj tiene un problema con algunos equipos que luego de varias semanas empiezan a dar problemas con el swr
-
K. Kindt
> 3 dayMakes the use of separate antennas in my shack easy. I havent found a noticeable change in swr with this in line.