Mitutoyo 050101, Edge Finder, 3/8 Dia. Shank, .200 Dia. Tip

This may be the lower quality of the Mitutoyo line but this edge finder gives me much greater repeatability than my SPI. I am using it at a max of 700 RPM with outstanding results. Totally Satisfied.

Worked like it should worth the buy.

Its an edge finder. It works smoothly and repeats well. Its Mitutoyo, nuff said!

Works as should

Great edge finder for the manual mill. This is a replacement for a Starrett edge finder that broke and it is every bit as well made and high quality. I also ordered a few cheap Chinese edge finders and wish I had not. In terms of quality this is a far superior tool

Value for money

My last mitutoyo edge finder lasted 15 years would still be using if a newbie wouldnt have ran into part and broke it.

It could use a little hand finishing to remove a burr here and there. After about 5 minutes of finishing it works great.

Works very well but should come with instructions as some of us are new to making use of things like these. I had to learn how to use it from YouTube.

Accurate and repeatable