Naviurway Windshield Washer Squirter Nozzle Spray Jet Kit with Fluid Hose Connector Compatible for Jeep Grand Cherokee Chevrolet Malibu Pontiac G6 Saturn Aura Replace Parts OEM # 55079049AA (7 in 1)

Very poor materiel quality, sprays at an uneven angle, hard to install.

The softer hose is easier to work with than the stock hose. However, every single spot where there was a connection would disconnect due to the pressure in the line, since the hose is so loose. I was able to work around this by using a zip tie at each connection point to secure the hose around the adapters, but not before squirting washer fluid all over my engine compartment as each one popped off one at a time. So this will work, but will take more DIY-ing than if you were to just buy an OEM replacement. Ok for the price though.

Easy installation and works great.

Tubing not long enough to reach reservoir. The photo shows to what location the tubing will reach.

I Tried to use these on my 2005 Chevy Malibu. Because Amazon Said that they would fit my car. Come to find out the hose was to big and i needed four sprayers. This kit only came with 2.

Very satisfied

The nozzles dont hit the windshield in my 08 jeep grand Cherokee they spray the cowl and splash onto the windshield they dont have any adjustment

The tubes are a little too long and when installed one of my sprayers doesnt point high enough. Its installed exactly like the other so its something internal. A much cheaper alternative than getting it fixed at the dealer or a shop and it was easy enough to install.

This product is garbage. The spray doesnt reach the windshield. I ended up buying OEM spray nozzles and they work 100% perfect. Dont buy this product since it doesnt work. Nozzles were also hard to snap in. No such issue with the OEM nozzles I bought. I had to throw these away. What a waste.

This product lists compatibility with 2014 Jeep Grand Cherokee. Is it not. For starters the supply tube is about 3 too short. Luckily the break in my hose was near the hood hinge so I was able to splice it and still use the provided hose. Also the nozzles are garbage. Two issues...1) They squirt a heavy jet of water on the hood and bottom of windshield near wipers. Original nozzles were more of a mist and centered on windshield. 2) The gaskets are die cut and way off center. I had to trim them to keep them from sticking out on one side.