Noctua NH-U12S chromax.Black, 120mm Single-Tower CPU Cooler (Black)
-
Knapp
Greater than one weekSuper einfach zu Montierten. Die Qualität ist einfach der Hammer. Flüster leise und die CPU wird optimal gekühlt. Das schwarze Design passt super in ein Modernes Gehäuse. Für jeden der nicht unbedingt rgb braucht sondern top Qualität ist hier genau richtig.
-
Davide
Greater than one weekTotale qualità e servizio del prodotto, indubbiamente vale il suo prezzo.
-
Vespasion
> 3 dayThis was easy to install and works well. I never get heat alarms with this cooling system.
-
jackie
Greater than one weekWell worth the money, shipped really fast
-
Bernard
> 3 dayGood quality air cooler and the limited edition Linus Tech Tips anti vibration rubbers are cool.
-
kk
> 3 dayI switched from a stock Intel cooler to this Noctua NH-U12S. My idle temperatures were immediately down by 10 degrees. Under a full load, the impact was even greater with temperatures dropping by 16 degrees.
-
Diogo M.
Greater than one weekEm ventilador es silencioso y esta todo hecho en negro mate muy elegante
-
Jack Clear
> 3 dayThis works far better than expected.
-
KODIAK59
> 3 dayrien à dire, si ce nest la qualité noctua est toujours au top
-
Damn Yankee
> 3 dayBeen reading lately that air coolers are as good or better than AIOs so decided to give this air cooler a try. I must say I m impressed: build quality and attention to detail is far beyond anything I am use too (mostly Arctic cooling the benchmark as far as Im concerned). The box came with easy to understand directions and everything, and some spares, that I could possiblly need Including a Allen shaped Phillps that really made installing this easy. I have a TUF Wifi M-ATX and this did not crowd the RAM which in my case is pretty tall. There is still room for two sticks of RAM and another fan on the cooler. This lowered my temps on a 5700g from 89 C to 67C on Cinebench. What I liked most were the directions that told me to just put a pea size drop of thermal compound (included) in the middle of the dye and tighten ALL the screws to 6 Nm. I think if everyone followed these directions even a first time builder could get good results. The directions explained that 6Nm is just tight, no further. It uses the the stock back plate and only the two side panels need to be removed to install. This matches a Coolermaster 120 AIO with two 120 MM fans and radiator that I have installed on a 2700X. another plus is there are no LEDs and the wires which are usually a pain in the neck. Cheaper than an AIO, fits in most, 99% of cases, and almost dead silent. I can hear it ramp up when I start Cinebench , but I have to listen closely. Will buy this again if any of my computers need a new cooling solution. The Engineers at Nocturna really thought this one through, Bravo.