Noctua NH-U12S chromax.Black, 120mm Single-Tower CPU Cooler (Black)
-
Zachary
> 3 dayThis heat sink and all involved parts feel very premium -- no sharp corners on the metal and everything fits securely in place. My spec list is:
-
Hailey K.
> 3 dayI have used Wraith Prizm, Pure Rock 2, Wraith Stealth....etc but among them, I have chosen this over any other cooler.
-
Juan Castillo
Greater than one weekReally not much else to say. Good quality product as usual.
-
Gabriele1990
Greater than one weekVeramente incredibile, differenza di temperature dal diss. Stock notevoli
-
Prof. Macey Pfeffer
> 3 dayRelatively easy install, could have been easier if I didnt do it by myself but regardless, temps down almost 20 Celcious (From 65-70 to 45-50) under load and about 8-12 degrees while idling. Love this baby!
-
Noah Kohler
> 3 dayOne of the best mounting system and Ryzen 5600x Does not go over 70C when auto overclocked.
-
fabrizio
> 3 dayottimo prodotto
-
Dr. Scifant
> 3 dayFairly easy to mount, good temps and nice and quiet. No fuss, no muss
-
Chad Sarvis
> 3 dayGreat product! Bought this as part of a refresh of one of my older PCs. Definitely don’t regret it! Easy install and it looks good in the all black build.
-
Damn Yankee
> 3 dayBeen reading lately that air coolers are as good or better than AIOs so decided to give this air cooler a try. I must say I m impressed: build quality and attention to detail is far beyond anything I am use too (mostly Arctic cooling the benchmark as far as Im concerned). The box came with easy to understand directions and everything, and some spares, that I could possiblly need Including a Allen shaped Phillps that really made installing this easy. I have a TUF Wifi M-ATX and this did not crowd the RAM which in my case is pretty tall. There is still room for two sticks of RAM and another fan on the cooler. This lowered my temps on a 5700g from 89 C to 67C on Cinebench. What I liked most were the directions that told me to just put a pea size drop of thermal compound (included) in the middle of the dye and tighten ALL the screws to 6 Nm. I think if everyone followed these directions even a first time builder could get good results. The directions explained that 6Nm is just tight, no further. It uses the the stock back plate and only the two side panels need to be removed to install. This matches a Coolermaster 120 AIO with two 120 MM fans and radiator that I have installed on a 2700X. another plus is there are no LEDs and the wires which are usually a pain in the neck. Cheaper than an AIO, fits in most, 99% of cases, and almost dead silent. I can hear it ramp up when I start Cinebench , but I have to listen closely. Will buy this again if any of my computers need a new cooling solution. The Engineers at Nocturna really thought this one through, Bravo.