













OMT 60 PCS Tap and Die Set Metric and Standard Sizes Included Tap Die Kit Metric and SAE for Threading and Rethreading Internal and External Threads
-
Xiaoyu
> 24 hourThis set will break with a single hand turning a bit with the wrist - the whole arm - and no cranking power. The bit snaps off with a single hand turning rather mildly in an aluminum metal simply to be rethreaded at the same thread as already previously threaded. I am angry with this product. The material is not manufactured properly. When the bit snaps off in your piece there is virtually no way to get it out without destroying the piece being threaded making you spend money and time purchasing component part for your device. These guys should not sell this product!
-
Fred E.
> 24 hourI have to say to be cheap Chinese made junk they’re actually a pretty decent set of Taps and Dies
-
M. Barnette
> 24 hourI tried tapping a 1/4-20 hole in a piece of 6160 aluminum. The cutting teeth began wearing away immediately and then the tap broke off in the hole. I’ve used tap and die sets most of my life. This set, by far, is the worst one I’ve ever used! You will be getting this back!
-
Ronald G.
> 24 hourProduct is in the average Quality to be made in either Taiwan China etc. be careful how you use it so you don’t break any of the taps off but it gets the job done
-
Cynthia Hurt
> 24 hourIt might not get used everyday but it’s nice to know you have it when it’s needed. And it’s is good for mechanic to use.
-
Max
> 24 hourI immediately utilized this kit for a motorcycle repair. It worked great.
-
Lisa Robertson
> 24 hourPretty well made for my use as a garage sale
-
SomeGuyWithManyHobbies
> 24 hourI used the taps for cutting threads in my 3D printed stuff. For that purpose, this set is OK. However, when I needed to cut threads into brass and steel bolts, the poor quality of the dies was immediately evident. The dies were difficult to start, even over the existing factory threads. Once I did get the die started, it absolutely chewed up the crisp factory threads. Once I got to the end of the factory thread, the dies all but stopped cutting. After backing the dies off of the bolt, what was a crips factory thread was now so messed up that the bolt no longer fit. I have not tried the taps into metal because I dont want to risk breaking off a tap. Overall, the taps are OK for plastic. I wouldnt trust them for metal. The dies are total garbage. What I ended up buying here is a case to put better quality tools into - as I buy them 1 piece at a time.
-
Angela D. Kelley
> 24 hourQuality for the price.
-
Tom Spiers
> 24 hourHas all the sizes I need all in one place