Opret 5 Pcs FEP Release Film Replacement for ELEGOO Saturn/ANYCUBIC Photon Mono X LCD 3D Printer 185x260mm 0.15mm Thickness 95% Light Transmittance for 8.9 & 9.1 inch Screens

Print wise, I have had no issues with this film so far and I am 3 prints in. However, in line with some other reviews, I did receive the 2-piece after ordering the 5-piece set. I triple-checked to make sure I did not accidentally purchase the wrong set. Just make sure to check you received the correct order before you open the wrapping or remove your current FEP film as I did.

Went on easy. Instructions were clear and concise. I also learned, from these instructions, that one is to remove a film on each side of the fep film. Well, that explains an issue I was having with another cheap brand. Ill have to go back and give them another go, though if they had said as much on their packaging I wouldnt be in this mess to begin with, so who knows.

it tore just from leveling the print bed multiple times. i legit thought it was my fault the first two times until it did it again. after the first time leveling it.

Muy caro para el material y función

perfect product, no complaints, theres extra that needs to be trimmed once you fit the sheets between the two metal plates. very clear product, no blemishes or scratches on the sheet

opened this up thinking, this doesnt look like it will fit, and sure enough, its only 130mm wide.

This won’t work with the Anycubic Photon Mono stock vat. If however, you replace the vat with an aftermarket one (for example aluminum) then they work great. We replaced the vat as I wanted to be able to use lower-cost FEP replacement than Anycubic’s and it also doesn’t tie me to worrying about their stock.

did not seal leak all over

Received a 2 piece set instead of a 5 piece. Make sure your getting what your buying.

Good funcionality