Original Ender 3 Pro Bed Clips Clamp 7mm for Creality Ender 3 V2 Ender 3S Ender 5 Pro Ender 7 CR-20 PRO CR-10S Pro 3D Printer Heated Bed Glass Bed Platform (Bed Clips)

Bought these for an Ender 5 Pro with the glass bed upgrade. I did not remove the magnetic sticker below the original print bed. Had to strech these out to fit, scratched the glass. You will need to remove that magnetic layer first! This is probably mentioned in other reviews that I did not see. No instructions or anything so dont throw caution to the wind like me!

Worked as it should

These metal clips gouged into my heated bed to the point it created short circuit and ran power back into the mother board. Destroyed my two month old Ender 5 Pro. $400.00 lost because of these $8 clips.

Perfect fit for Ender 3 v1 with creality upgraded glass bed. using paper clamps was causing my bullseye mod fan duct to hit the clamp. These fit perfectly and have super low profile.

Always have these around and are much better than the binder clips that come stock with most printers

This fixed all my problems. My crippling debt, My divorce, and my depression. When I saw this product I knew it would turn my whole life around and make myself become better. I am now a multi billionaire I no longer have depression and my wife came back with the kids. This is the best product ever I am glad I made this purchase.

These clips were the perfect match for my replacement tempered glass print bed. They are low profile, easy to attach, easy to remove, and they firmly affix the glass to the plate. Even after tons of prints and vigorous scrubbing they havent moved a bit. Definitely a must have.

The clips were a little to large for my bed, my bed isn’t thick enough for the clips to clamp. I fixed that by compressing them smaller than my bed thickness so that it will pull the glass right to the heated aluminum.

Excellent when paired with the Creality glass bed on my Ender 3 Pro. Very secure and much more low profile than binder clips.

Pros: Heavy Duty Red Wheels; Silicon Spacers; Holding great using only M420 S1 for abl. Cons: Was a bit of a pain to level, but doable. These work great so far. Been on a printer that I just built. Took a while to get the bed level, even with using bed leveling visualizer from octoprint; But now it is set and forget. I probes the bed a few times manually after each print for a few prints and it remained the same. Been printing 8+ hours a day for a week with M420 S1 gcode in place of G29 (load mesh vs creating a mesh every run) with 0 problems. Love it.