PrimoChill 1/2in. Rigid RevolverSX Series Fitting - 6 pack - UV Red
-
david k
> 24 hourAwesome fit and awesome looks
-
Andrew Kasperski
> 24 hourHard to turn the fittings in. Should have designed it with an Allen key in the inner diameter.
-
Tristan Holley
> 24 hourPerfect fit. Easy installation. Just be careful the paint is able to be scratched.
-
KC8VFA
> 24 hourworked as expected.
-
Nolan Rabe
> 24 hourLooks clean and works well with Primochills 1/2 OD 3/8 ID PETG tubing. Ive had them installed for a little over a month now and no leaks whatsoever and this was my first built using water cooling so huge relief not to have to deal with that nightmare. Only gripe is cost. Your build gets costly real quickly the more you need. If I did had it to do over I would have just gotten the 12 pack cause I ended up buying more anyways. 2 for radiator, 2 for cpu block, 2 on a t block I was originally using for draining and then 2 at least for reservoir. You get the idea
-
Michael Plummer
> 24 hourI got 12 of them, they all work. no leaks
-
Richard Patrick
> 24 hourExcellent for my water cooled rig.
-
jay
> 24 hourIve tried a lot of different fittings, these are by far the best ive used. Easy install and great compression, its seal tight. they are a tad bigger then most other fittings though so be sure you have clearance when screwing them down next to radiators or other components. Mine where fine and fit perfectly next to my components. Corsairs hydro x water block, d5 pump/res combo and their 280 mm radiators.
-
Nina
> 24 hourEasy to use some threadind a little sharp on edges but not bad.
-
Mrcamaro
> 24 hourLooks great easy to use without worries about pinching o rings and looks great
