RCBS Single Stage Shell Holder, Hardened Shell Holder for Reloading on Single Stage and Turret Presses

Excited to finally have dies for my Mauser

I was worried at first about this being a real RCBS shell holder. The info for it on Amazon was iffy. Under country of origan it says Holly See, what does that mean? I ordered several because I like to have one for each set of dies and keep one in each die box. When they came they were in fact real made in USA RCBS shell holders. and at a great price.

Great shell holder. Works in my rockchucker press as it should. Perfect fit for my 7mm-08 cases.

Its working good

Another quality RCBS shell holder. However, it doesnt fit 10.4X38R (41 Swiss) Swiss Vetterli Centerfire Cases made from Lebel brass. I suppose it fits the .348 Winchester brass perfectly, except I dont have any of that brass to compare. The Lebel brass has a slightly larger base and wont fit the #5 shell holder. I had purchased this shell holder on the presumption that it did after what I thought was thorough research on many forums. However, once I receive it, I found it didnt fit the Lebal brass. I later found the LEE #17 fit my Lebel brass perfectly and I ordered three from another vendor on Amazon. In summary, some hand-loaders use re-formed .348 Winchester brass for the Swiss Vetterli, and this shell holder should work fine for that. Others use Lebel brass and this shell holder will -not- work for that brass; go get a LEE #17 instead. I now have an RCBS #5 I dont really need, but small price to pay for the education. :)

One more product you will need. Said before they should have kits for different ones.

I have been using RCBS reloading products and tools for over 50 years. In my opinion they are the best on the market.

Like easy to use

The quality is as good a Hornady. I wish that the priming hole was the same size as Hornady; that is my only complaint. Otherwise it works quite with my Hornady Lock n Load equipment. Normally, I would have purchased Hornady, but the one listed for Hornady was the wrong description, and was sent one for a .40 cal. I can use it so I did not send it back, and just went ahead and ordered the RCBS. Again, my only complaint is that the priming hole is smaller than Hornady.

This shell holder fits my 7mm WSM as intended