REETAI-FOUR 10Pcs TCT Hole Saw Kit,Tungsten Carbide Tipped Hole Saw Set, Hole Cutter Heavy Duty for Stainless Steel.(5/8-2-1/8”).
-
AUTISTICWEREWOLF
Greater than one weekThe drill bits have this nasty habit of unscrewing with use. If everything holds together these drill bits work fine on light weight metal studs. If you are drilling through the old thicker metal studs you will need an impact drill in addition to this item.
-
Marek Kaczka
Greater than one weekAdvertise as imperial but they are metric
-
Gypsy
> 3 dayWorks well
-
Eliseo Ramirez
> 3 dayWorks great sharp and cuts good through stainless steel 16 gauge up to 3/16 that I used them on. Wish they would co e in a sturdy case. Only individual case.
-
Nick
Greater than one weekThis product made it 3 holes before failure. All teeth are destroyed. I know these are vheep but they are trash. Hols look like they were cut with normal holesaw. Do not waste time or money on these.
-
Jason
> 3 dayEven if you use oil these scream on a low revolution drill press. they dont seem to bit into the metal very small shavings/chips. The kit itself is nice, spring loaded to push the metal plug out. They work just takes some time.
-
Jhon G.
> 3 dayEveryone of them broke on me at our 1st job of the day . I had to buy another set . The customer service was pretty good
-
Mark A
> 3 dayNot sure how well the are for stainless but itll cut mild steel with ease
-
Jesse
Greater than one weekThese are the cheapest made junk you’ll ever buy, please save your money and buy a quality set! I am a professional machinist so I know what lubricants, coolants, cut rates and so on to use I do this day in and day out and the first bit I used lasted 4.5 seconds before it sheered in half by twisting the shaft right off!
-
Justin D
> 3 dayI knew these were going to be cheap, but not this cheap. They come with the worst pilot bits Ive ever seen. I snapped 3 pilot bits within the 1st few uses. After changing to better pilot bits now the carbide teeth are breaking off. This is the 1st week Ive used these bits with only being used on electrical panels which is thin steel. Buy something else
TCT Hole Saw Kit
- It can be held by hand drill and bench drill.
- Made of carbide alloy steel material,excellent performance.
- Sharp edge, wear-resistant,good drilling capacity.
- Used for steel plates,cast iron,stainless steel,other open metal hole.
The best effect: steel plate within 3mm and iron plate within 10mm.
Steel and iron plates can be drilled up to 20mm thick, but please pay attention to the operation.
Wide range of application
|
|
|
|
|
|---|---|---|---|---|
| 9PCS Dry Vacuum Brazed Diamond Drill Bit Kit | 7PCS Masonry Drill Bit Set | 10PCS Concrete Hole Saw Kit | 17 PCS Rotary Hammer Drill Bits & Chisels Set | |
| Number | 9PCS | 7PCS | 10PCS | 17PCS |
| Application | For porcelain, glass, marble, ceramic, rock and granite etc. | Ideal for drilling through red brick, glass, concrete, ceramic tile, plastics, wood and More. | Prefect used for Brick, concrete, cement, stone, mixed brick wall, foam wall and installation of air-conditioner. | working on concrete, masonry, wall, bricks, stone and road. |