

RWM Casters DUR-0620-08 6 Diameter X 2 Width Durastan Phenolic Wheel with Straight Roller Bearing, 1200 lbs Capacity, 1/2 Axle Diameter, Black
-
Bruce and Sandy
Greater than one weekPerfect fit
-
Scott W.
> 3 dayExactly what I needed as replacements for my 4 wheel flat bed 400lb capacity cart. Much cheaper than local stores. They fit perfectly and donot mark the floors.
-
Buddy
> 3 dayI replaced the hard plastic wheel that came with my boat with this wheel. It was an easy replacement and now I can maneuver my boat with ease in my garage. Highly recommend.
-
Dan R.
> 3 dayI like it has bearings and is a hard plastic like old roller skate wheels.
-
BoaterGuy
> 3 daygreat improvement over original wheels on trailer tongue jack from Harbor Freight. These wheels have roller bearings and a machined shaft sleeve. Just add grease. However, the shaft sleeve is 3/16 longer that the original cheap shaft sleeve from HF. Shortening the new sleeve was necessary, as well as a longer 1/2 shaft bolt.
-
Bennett Ullrich
Greater than one weekFit these on a u-boat that takes A LOT of abuse with heavy loads. Previous wheels were two-piece and shattered when hitting bumps. These wheels roll buttery smooth and seem to be holding up extremely well to the torture.
-
Felix
> 3 dayIve ordered several casters for a dolly/truck that carries a huge amount of weight and none works better than this one. Very easy to install, incredibly sturdy, and the cheapest too! Ive ordered 2 of these already, now ordering 2 more!!!
-
robert
> 3 dayExact replacement
-
R Cagno
> 3 dayI purchased this to replace a broken wheel on the tongue jack on my utility trailer. The original was a cheap brittle plastic and the wheel itself just broke around the outside of the bearing. This Caster is extremely well made. It is made of Duristan Phenolic (Im not sure what that is, but it is extremely tough and durable). It is rated for up to 1200 lbs. and was a direct fit for my jack. I merely had to remove the axle screw, pull the bad wheel out, put this one in and replace the axle screw. Since installation the trailer rolls better and I dont see this wheel breaking under any sort of normal use. This was worth every penny and more. Great product at a great price.
-
ddp
> 3 dayThis is twice the wheel compared to the original. Though the bearings arent necessary for my purpose they do show value for cost, which is surprisingly low - also in comparison.