Saker Silicone Caulking Tools-3 in 1 Sealant Finishing Tool Grout Remove Scraper (Stainless Steelhead),Caulk Remover Glass Glue Angle Scraper for Bathroom,Kitchen,Floor,Window,Sink Joint,Frames Seal

Right out of the box, one of the nubs that holds the caulking heads on was busted off. Still was able to make it work but each time I needed to wipe the head off, it would fall off. Due to time restraints on next phase of our remodeling I used it as is. Other than that problem, it works pretty well

More detail instructions with the tool. Plastic tool not heavy enough to prevent breaking.

Wasn’t the greatest tool but I managed to get by.

Easy to use Take old calking off easy

Fast and easy to use. Removed old chalking without any problems. New chalking looked the same as when we first moved in 4 years ago.

Two screws on each side scratched the countertop.

Very small and lightweight. Not sure, highly doubtful,that this could stand up for much longtime and hard usage. Thin plastic. Im in construction and this seems very flimsy. Im seriously afraid to even use it for fear itll just snap. Maybe good for small dainty jobs and people. And I know about tools. But just my opinion. Enter at your own risk

WORKS GREAT

Great little tool. Done the job as needed on renewing toilet seals. Got the old stuff off with ease (and some elbow grease). Got a little lost on the part you can use for smoothing chaulk/silicone out. Turn the tool so your looking inside and there are 2 small screws. This allow you to adjust the smoother part out past the scraper. Completely missed the on first use lol. Definitely great for home DIY, prosseional wise not so sure. It is plastic but sturdy, however I doubt it would like too much pressure on the main part for extended periods. So much better suited for home DIY work. All in all though very handy tool and would recommend to others in need of something for that bathroom/kitchen/toilet renovation. Not too small but small enough for tight areas. Great sharp cutter on it for old chaulk removal.

Might be okay removal of silicon in tightly fit corners, but where there is a gap filled in not so much, had to switch back to putty knife and razor blade (+ butter knife) to dig all the gunk out and clean up the tile surface. Havent gotten to use the finisher side yet, so Ill leave it at three ***.