









Silicone Rubber Sheet,Heat Resistant, Heavy Duty,High Grade 60A,12 x 12 Inch, 1/25 Inch Thickness for DIY Gaskets, Pads, Seals, Crafts, Flooring,Cushioning of Anti-Vibration, Anti-Slip
-
robert gusoskey
> 24 hourThis is a poor quality item . Describe as 12x12 I ordered 2 just in case and they are both odd shaped junk if you not going to make them square in shape with straight cut line side at least make them over sized so they can trimmed so they will be 12x12 . Straight JUNK !!!!!
-
Trekker140
> 24 hourBought to be gasket for hobby paint jars that had no gaskets for the lids. Using for enamel paints. Cut and installed flat in the cap, to the edge. After a week of storage of enamel paint, when cap was removed, the rubber material bowled. Unable to reuse since it was bowled and was thinner than when installed, unable to get seal, had to cut new piece.
-
RP
> 24 hourWorked great for my project. As others have mentioned it’s not square.
-
ArifMah
> 24 hourI wish i had checked the tkickness. It is too thin to make the washers.
-
Jay peryot
> 24 hourThe other one is in the trash-burned
-
jim t
> 24 hourNot good Fuel tank gasket material
-
Angelina Tremblay DVM
> 24 hourI was using this to line a mold to melt plastic into different shapes. Its kind of pricy (since I had to cut it up) But it worked good in the oven at 350F
-
Lisa.
> 24 hourWorked for what I needed. There was a hole in our RV floor where some tubes run to the outside. I used this to make a mat basically that covered the hole but let the tube through. Then glued it all down. (If the glue sticks to the silicone is another matter) but it will keep pest out so does the job.
-
ITguy
> 24 hourSaw the description that the silicone sheet was heat resistant and decided it would make good replacement gaskets for my Origo alcohol stove. Seems to work well!
-
Jack Conrad
> 24 hourEasy to work with