skineat 3 Pack Computer Case ATX Power On Off Reset Switch Cable with 2 x LED Light Light Red Green 27-inch ATX Case Front Bezel Wire (2-Pack)

Looks ok, just got it yesterday. not as long as I thought.

lo compre ya que me facilita la conexion en PCs de test

Nice product for on/off switch.

Only had red and green LED lights, My case has red and clear. I can live with that. I am very happy, easy to install, Although I need some hot glue to hold down the switches. I think a low temp glue gun would be the best solution to hold down the LED wires and switches.

I had to get a replacement bunch of switches for a PC case I broke almost every front panel connector for, and I found these. the Power switch conveniently was already molded for the power button and fit perfectly. the HDD LED works just fine, the Reset switch also worked perfectly fine. I could not for the life of me get either Power LED to work. Both sets didnt work. I had the correct Pinout, and I couldnt get anything out of either one. the power LED for my old case worked, but neither of these did.

The price is definitely right, and it actually does work as intended. There’s really not much to say. It’s just a bunch of LEDs and switches. I will say, however that the HDD light, which is red, is ridiculously bright! I’m not sure if that’s just due to this particular light or maybe my motherboard is weird. Otherwise, this is a great way to add some switches are lights to a computer case that doesn’t have them.

The cables were a little tight for my large Tower computer case so I patched about 12 inches extra to my HDD LED cable and Reset Switch cables which were the only ones I needed at this time. The HDD LED bulb was twice as large as the original HDD LED that came with my computer case but I simply used a Soldering Iron to enlarge the hole and now it fits and works great. Nice and bright RED light. Very pleased with this purchase and product. Note: I didnt use the micro-switch since I replaced the Reset Switch with a much larger switch but use the cable and Reset switch connector instead.

Really only wanted this for the HDD LED which my case lacked. Works good, have it mounted a bit out of the way so I can still see if the drive is being accessed when I want (like during boot) but doesnt ruin my aesthetic. Only issue, they should do a version with black wires instead of white.

I bought these because the three pack of a full set of LEDs and switches was less expensive than a single reset switch. I needed just a single switch, to connect to the CMOS reset pins, for overclocking failures. $8 for a single switch... or $6 for 3 sets (6 switches total, and 6 LEDs as well!) I mean, honestly, its the standard set youd get in any ATX case. The power LED connector is split into 2 1x1 connectors. The rest are 1x2 connectors. Im planning to use the reset with my TTL logic kit, so extras for that at no cost! :D

Only had red and green LED lights, My case has red and clear. I can live with that. I am very happy, easy to install, Although I need some hot glue to hold down the switches. I think a low temp glue gun would be the best solution to hold down the LED wires and switches.