Snappy Tools Plug Cutter, 3/4

Remodeling our deck and I needed to plug some 3/4 holes left by the last railing. Used the same material that the deck was made of and this cutter cut EXACT size I needed. Realy like the taper. Makes the plug go into the hole easily and then snugs down to make a perfect fit.

I used it to cut plugs and wanted side grain to match the door instead of a dowel with end grain and it shows up too easily. The oak plugs I made looked great. Now I have the 3/4 to go with the rest of the SNappy kit.

I saw some other reviews saying that they broke this plug cutter but I cant imagine what they were trying to cut or do with it. I cut plugs out of red oak, an extremely hard wood, with no problem. This plug cutter is strong and sharp.

Liked the ease of producing plugs.

I received this 3/4 inch and a 1/2 inch plug cutter from Bowers Tool promptly. Both are well made and Im glad to have an American-made product! I tried the 3/4 inch cutter in my drill press at 540 RPM on a piece of pine. It made a neat, clean cut with apparently little effort. I took my time to avoid overheating the cutter, and there was no burning of the wood. Im pleased with these cutters and highly recommend them and Bowers Tool.

I cut 10 plugs in 3/4 hard red oak flooring to plug some 3/4 holes in my floor. Max plug depth is about 0.50 with the cutter all the way down. Some burning of the oak can be seen in the pictures which I was unable to avoid with any speed or cut pressure. Best performance was at 450RPM and light feed pressure. These plugs were cut with a table saw at 0.47 long. The tool produces a tapered plug with a slight radius at the small end to aid in insertion. Small diameter is 0.742, large diameter is 0.762. This produced a good interference fit into a 0.75 hole. the tool seems well made and other than the slight burning, performed very well. For comparison, I cut a straight walled 0.745 plug using my CNC router and .125 bit. I ended up using the tapered plugs.

Cuts at a .758. I use a 3/4 forstner bit on a drill press, so it is a perfect hole. I would prefer a little larger as it is possible to tap the plug too hard and push it below the surface, especially with soft wood, but I imagine all woodworking is about finite measurements and delicate operations. I tested first, so was aware of the diameter and hence measured with calipers. Once I was aware how close it was, I just ensured I left about 1/16 above the surface and routed with a flush bit. Perfection achieved.

Did exactly what I needed it to do. Which was cut a bunch of plugs for a wood floor. I used this and the smaller 3-pack. I highly recommend a drill press. I want to say you NEED a drill press, but I know some of you will be all, “this guy is an idiot, I did it freehand.” And maybe you did. The smaller ones you can get away with it, but even then you’re going to wander, and if you a have super smooth surface and plenty of material and time, then yeah. But this one, forget it. My only complaint is that it can’t quick change and I was drilling many different sizes.

It worked fine it worked fine

Help me a lot