

SPEED TIGER IPVE Carbide Square End Mill for Stainless Steel - Unequal Flute Spacing & Helix Design - Anti-Vibration - 4 Flute - IPVE1/44 - Made in Taiwan (1 Piece, 1/4)
-
fact
> 3 dayWorks as described
-
Justin Kwasny
> 3 dayIve gone through my share of endmills and they always burn up as with a 24k rpm spindle, going less than 3000RPM is not easy as the torque available is almost nil. I bought one of these for hardened steel and stainless steel I needed to mill and this endmill Ive got actual cutting time so far 6 hours contact in hardened steel and 11 hours in stainless steel total and this still cuts like a hot knife through room temperature butter. 3137 rpm at around 650mm/min works great in either metal. 1st order from this company and wont be my last, in fact all my purchases will be from this company.
-
craig
> 3 dayWorked great
-
brian
> 3 dayworks great in stainless st
-
Douglas H
> 3 dayUsed this in my hand held air grinder. Works amazing, sharp, cuts great, proceed right, easy yes to buy this EM
-
Aiden Streich
> 3 dayGreat endmills. One 5/16 has milled the outside all of these in 304 stainless and still running.
-
Chris
> 3 dayThis endmill cut .06 deep flats on 304 stainless 800 times. Then cut some plastic because I was too lazy to change it out. Cut like butter. Nice product!
-
sheryl keon
Greater than one weekPerfect as described
-
Toon
> 3 dayI ran 100pcs at 5000rpm, 80 ipm and dry no coolant with .055 radial cut at 1 deep, 2 endmills did the whole job! Dont believe take a look at high speed machining on SS on the tube!