SpeTool Extra Long Spiral Router Bit Down Cut 1/8 inch Cutting Diameter, 1/4 inch Shank 3 inch OVL HRC55 Solid Carbide End Mill for Wood Cut Carving Engrave

I was using this for the first time and the bit broke on me within a minute of use

This bit was clean cutting and long enough for my 3/4” thick material (wood) on my XCarve!

Really like the length and reach however cutting even at slow feeds and shallow doc seemed to much. But just seems dull compared to other brands I’ve used.

Never buy any bits or tools made in mainland china. I realize the price is hard to pass up… But they are never worth the price a dog they break or they don’t work in the first place. For some reason China cannot even make a machine screw to tightly turn into a machine nut

Broke almost immediately and was cutting with its set specs listed...so so disappointing..

I use these a lot. They work great but with a long small diameter cutter like this it is not too difficult to break them. These are great quality and value.

Just what I need for the project I am doing with my daughter

No issues with this bit whatsoever at first. I use it on my X-Carve and it works perfect! The bad part that it became dull in about a month or so. Does not have a long life. If you buy just keep that in mind.

Broke under normal carving parameters.

Broke in first 4 min .1 DOC 45 in/min speed. I bought 2 because they were same day shipping and needed them ASAP and I was afraid one would break. Ran the second bit at .09 ODC and 40 in/min and it worked fine.