SpeTool Extra Long Spiral Router Bit Down Cut 1/8 inch Cutting Diameter, 1/4 inch Shank 3 inch OVL HRC55 Solid Carbide End Mill for Wood Cut Carving Engrave

Just what I need for the project I am doing with my daughter

No issues with this bit whatsoever at first. I use it on my X-Carve and it works perfect! The bad part that it became dull in about a month or so. Does not have a long life. If you buy just keep that in mind.

Broke in first 4 min .1 DOC 45 in/min speed. I bought 2 because they were same day shipping and needed them ASAP and I was afraid one would break. Ran the second bit at .09 ODC and 40 in/min and it worked fine.

Really like the length and reach however cutting even at slow feeds and shallow doc seemed to much. But just seems dull compared to other brands I’ve used.

The bit snapped after routing out a few butterfly joints. Lasted less than an hour of use.

Broke almost immediately and was cutting with its set specs listed...so so disappointing..

I was using this for the first time and the bit broke on me within a minute of use

Made all the cuts I needed with ease. I was nervous some of the more demanding cuts would break it, but I was wrong. This bit is a champ.

I use these a lot. They work great but with a long small diameter cutter like this it is not too difficult to break them. These are great quality and value.

Broke on the third pass on the MDF my students were cutting.