













SpeTool Single Flute (O Flute) Spiral End Mill Aluminum Cutter Carbide Router 1 inch Cutting Length with 1/4Inch Shank for Aluminum Acrylic PVC MDF Plastic
-
todd heath
Greater than one weekI run lots of different bits and this brand is one I can for the most part count on as being a decent bit. Not the best but not the worst brand. I have had pretty good luck with the brand but have had a few that didn’t last very long or just not up for the job. They are not super expensive but not cheap ether. With so many choices I can usually count on them. If i am doing a big job or something that is really precise i don’t use them I will use a brand I trust a bit more. Not saying this is a bad brand.
-
Fue V.
> 3 dayCarve like butter. This bit was surprisingly great on the xcarve. I had no issues.
-
K. Williams
> 3 dayI used this to cut slots in an aluminum extrusion. It worked much better than Id expected.