SpeTool Spiral Router Bits Down Cut 1/4 inch Cutting Diameter, 1/4 inch Shank Solid Carbide CNC Bits End Mill for Wood Cut Carving Engraver

I ordered this for use in my CNC router. Had a production run of wooden pen cases to cut out (walnut and maple) and needed to order a new bit to avoid tearout. Took a chance on this one because the price was low. I wasnt expecting much, but its still very sharp after cutting for 12+ hours. Might be just a hair bigger than 1/4, as my 1/4 indexing pins were a little loose in the positioning holes that this bit drilled. Regardless, Ill order more of these for future jobs for sure. Very happy with the cut quality and tool life.

Very good tool, have used it on approximately 100 ft of pine to trim out my boat.

Ive bought several sets of these CNC bits. We do a lot of profile cutting on a shop bot buddy. They cut cleanly and last quite a long time. And theyre much more affordable than the name brand bits. I havent had one break or prematurely wear out for reasons other than user error. Measure twice, cut once!

cuts clean. hopefully last long.

I was cutting a 1/32 inch deep 10.5 inch diameter circles in ¼ inch plywood to position a second part and the cut was not clean. Purchased this spiral router bits with down cut and it cleaned up the cuts beautifully. Two factors sharp bit and spiral router bit with down cut. All directions of the grain on the wood without a problem. Needed this tool for this job.

Down cutting bit. Very clean cut. This bit is very clean cutting and doesn’t leave a rough edge when doing cut outs on the cnc.

ESTA FUE UNA REPOSICIÓN DEL PEDIDO ORIGINAL YA QUE EL PRIMERO SE EXTRAVIÓ Y AMAZON AL DETECTAR EL PROBLEMA INMEDIATAMENTE ME ENVIÓ DE NUEVO EL PRODUCTO QUE LLEGÓ RAPIDÍSIMO. PROBÉ UNA EN MI FRESADORA Y LOS CORTES FUERON GENIALES. LO RECOMIENDO

I run lots of different bits and this brand is one I can for the most part count on as being a decent bit. Not the best but not the worst brand. I have had pretty good luck with the brand but have had a few that didn’t last very long or just not up for the job. They are not super expensive but not cheap ether. With so many choices I can usually count on them. If i am doing a big job or something that is really precise i don’t use them I will use a brand I trust a bit more. Not saying this is a bad brand.

Very good cutter for the money cut a very clean edge and keeping an edge.

Great value for the money.