Starborn Deckfast Fascia Tool
-
T.
> 3 day1 - leaves ragged counterbores 2 - 3 screws in to the job, the bit broke when it hit a piece of strapping, and this doesn’t come with spare bits.
-
Deb R
> 3 dayBest way to hang composite fascia. Looks better to just have two of these recessed color matching fascia screws every few feet, to hang the composite fascia, as opposed to trying to hide the screws. This tool drills the hole and recesses it all in one go. Gives some room for expansion and contraction. Tip: don’t fasten the screws too tight let it hang like Installing siding.
-
Mitch
> 3 dayInstalled composite fascia boards and this did a terrific job until the screw bit just fell out of the device and wont stay in.
-
Lisa V
> 3 dayThis worked perfect for our DYI. Facia screws went in easily, flush with the boards.
-
John B
> 3 dayShavings jam bearing, causing face to spin and burn/damage facia. A POS.
-
Philmographer
> 3 dayWorks perfectly for NewTechWood Fascia Board Screws. Not much else to say other than it does the job perfectly and is simple to use.
-
Cindy
> 3 dayWorks really good for the job.
-
Aaron Bunce
> 3 dayJust the tool for the job. When you know the tool, can search for it easily, and get reliable shipping, the planets align.
-
Paige
> 3 dayWorks but is not a perfect run through. Composite shreds are left after drilling bit
-
Gregory R. Peirce
> 3 dayI posted a question on how to tighten the drill bit. I was not able to answer my own question so here is what I found. A 3/32 hex tool will tighten it up perfectly! This is a wonderful tool to use to make the screw heads nicer to look at.
