Straight Router Bit with Bearing, Wolfride 4PCS Flush Trim Template Router Bit 1/4-Inch Shank Top Bearing Pattern Router Bit

bits are well constructed and cut nicely, but the 1/4 pattern bit is just over 3/8. Keep this in mind if actually using it for pattern routing, your template may be too thin for use with this.

These have done their job so far.

Overall the router bits are good. They provide good clean cuts. My only problem was that the set screw in one of the bits came out after only a little bit of use. I grabbed the set screw from one of the other bits and continued on.

If you need a cheap set of straight router bits for a job or two and don’t want to invest in a nicer set, this is for you. If you plan on using these consistently, they will dull and break. Upon initial purpose, they were sharper and performed better than expected.

These bits are a good deal for hobbiest

These router bits are sharp and cut well. The one issue I have is that the set screw for the bearing collar is too tall and hits the workpiece. I was able to file it down to get enough clearance, but its annoying to have to do this.

Sharp and working as should.

These bits look proper but as far as performance they fall short they butchered my materials and the bearing stop set screws vibrate out after a couple of uses they were sharp as butter knives definitely get what you pay for. Never again

good product worked well for me

While using the 1/2” bit on my first job in a piece of oak, the bearing disintegrated at 6 minutes. Now I’m stuck with a partially finished router job and I’m researching new bits. Should have realized that it was too good a deal to be true. Returning and looking for something else.